Author Topic: Vlans not showing up for HP Procurve Switches  (Read 1617 times)

sgottleb

  • Newbie
  • *
  • Posts: 5
Vlans not showing up for HP Procurve Switches
« on: November 08, 2016, 04:51:14 PM »
I have vlans showing up when i do CDP/LLDP discovery for cisco switches however for HP they do not show up.

JP

  • Newbie
  • *
  • Posts: 33
Re: Vlans not showing up for HP Procurve Switches
« Reply #1 on: November 08, 2016, 06:07:08 PM »
I would like to second this problem, works on Cisco, but not on Netgear switches.

By comparison, I tested with a Fluke LinkSprinter 300, and while it too could identify the switch port, it could not the VLAN.  This may have more to do with the switch manufacture's implementation of VLANs or switch port programming, as when a port is configured as an access port in just one VLAN, the "extra" traffic to determine the VLAN just might not be available.

I can create passive wireshark captures of each tester's traffic during a test, if that's helpful, but my capabilities are limited to 1 TX or 1 RX pair capture at a time (not both simultaneously)