Author Topic: Quicktest OK?  (Read 1610 times)


  • Newbie
  • *
  • Posts: 34
Quicktest OK?
« on: November 08, 2016, 07:00:29 pm »
Quicktest works again now that I updated to fw v22 - thanks!

Not sure if my results are right however...

When plugged into a switch port...
Shouldn't ALL the LEDs change color?
Here is a video:!AgUw4-P8zV0njE7CinEM0ptZUC-S
...I verified with other testers that switch is supplying POE (Mode A 53 to 54.1v depending on tester), and Gigabit link.
So I guess the only 2 red and 2 white LEDs confuse me.

When plugged into the wiremap terminator...
I always seem to get 4 yellow LEDs? I was expecting 4 Greens?
« Last Edit: November 08, 2016, 07:13:08 pm by JP »


  • Jr. Member
  • **
  • Posts: 81
Re: Quicktest OK?
« Reply #1 on: November 08, 2016, 07:07:12 pm »
Cool JP.  Nice view of your home made label.  That's about what I had in mind, but in color and on a clear sticker. They could just be printed in color on clear plastic as well and then mounted behind the bezel like you did.


  • Newbie
  • *
  • Posts: 15
Re: Quicktest OK?
« Reply #2 on: November 16, 2016, 11:34:26 am »
This sticker should be made official to make it easier to know what the LEDs do without consulting the manual.