Pockethernet Hardware > Issues

Strange test results


About a month before the announcement I noticed that all my results were not as I expect. every cable was testing bad.
After updating the firmware and app today. I notice that, again, every cable was testing with a 0m tdr and open. the wiremap would change depending on what is plugged into the other end. but nothing from a switch on link or a computer.  I am starting to believe that my PE has been damaged in some way.  Any steps I can try to fix it?


Hi Jack. Did you already do a hard reset? (Press the power button for 10 seconds, and then connect the USB plug)


I have done as requested. With the power off, I press and hold the power button for 10 Sec. then ran the f/w update, again.   same issues.


[0] Message Index

Go to full version