Pockethernet Forum

General => Feature Suggestions => Topic started by: Garry on September 19, 2019, 11:54:25 am

Title: Non-Ethernet wire test
Post by: Garry on September 19, 2019, 11:54:25 am
Currently, getting a wiremap from a non-ethernet layout cable does not work ("Miswire"). E.g., having an S2m cable with 1/2/4/5 and noting else will not result in any output, as both 3 and 6 are not connected. As PE is able to measure each wire with the corresponding remote end, I was hoping the software/firmware could be expanded to allow even single pair wiring (e.g. 4/5 for simple analog DSL cables etc.)