Pockethernet Forum

General => Feature Suggestions => Topic started by: allen.trigg on November 10, 2016, 12:47:17 am

Title: Diffuser for LED's
Post by: allen.trigg on November 10, 2016, 12:47:17 am
I'll be doing some experimenting and I'll post my results, my issue is i find it difficult to distinguish what colour the LED's are supposed to be. even with a paper label over the front.
blue, green and red are fine but as the other colours are a combination of these primary's all i see is lines of primary colour.

I'm going to try using a small blob of opaque hot glue on each LED, hopefully this will diffuse the light enough... hopefully this all makes sence.

just wondering if there are any other suggestions before i break the seal on my PE.

best regards

Allen